DeLonghi EV250.WH - Manual de uso - Página 11

25

• This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to part 15 of

the FCC Rules. These limits are designed to provide reaso-

nable protection against harmful interference in a residen-

tial installation.

• This equipment generates, uses and can radiate radio fre-

quency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or

television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following

measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and

receiver.

- Connect the equipment into an outlet on a circuit differ-

ent from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician

for help.

Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s au-
thority to operate the equipment.

• This device complies with Part 15 of the FCC Rules. Ope-

ration is subject to the following two conditions: (1) this

device may not cause harmful interference, and (2) this

device must accept any interference received, including

interference that may cause undesired operation.

• This Class B digital apparatus complies with Canadian

ICES-003.

5. SI ALGO NO FUNCIONA

Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Service.

PROBLEMA

POSIBLE CAUSA

SOLUCIÓN

El aparato no se enciende

El cable de alimentación no está
conectado

Asegúrese de que el cable de alimentación está
conectado y de que hay corriente

El aparato no está encendido

Encienda el aparato pulsando la tecla

(B1 en el panel de control o D1 en el mando a
distancia)

El aparato se apaga

El autoapagado se ha activado

Encienda el aparato y asegúrese de que el símb-
olo de autoapagado está apagado en el display

Humedad excesiva en la
habitación

Cuando se usa la función enfriamiento/
humidificación, el aparato produce hu-
medad por efecto del refrescamiento
evaporador. Es normal

El aparato refresca con más eficiencia en los cli-
mas secos. Si el nivel de humedad es alto (60%
y más), es mejor evitar el uso en la función
enfriamiento/humidificación
Asegúrese de que las ventanas/puertas están
abiertas y de que haya bastante aire corriente en
la habitación; a fin de que el aire pueda circular
mejor, es posible en todo caso utilizar el aparato
en la función ventilación