GE PWE23KYNFS - Manual de uso - Página 8

GE PWE23KYNFS

Frigorífico GE PWE23KYNFS - Manual de uso, léela gratuitamente en línea en formato PDF. Esperamos que esto te ayude a resolver cualquier duda que puedas tener. Si tienes más preguntas, contáctanos a través del formulario de contacto.

Cargando la instrucción

30

49-60792 Rev. 3

REINSTALLING THE
REFRIGERATOR DOORS

Reverse steps 1 through 4 to reinstall refrigerator
doors, follow details below for critical alignments.

A

Reinstall center hinge first

and torque the screws to 65
in-lbs (7.34 N-m).

With the LH

door at 90º to the front of the
case, lower the refrigerator
door onto the center hinge.
Ensure that the door and hinge align correctly.

B

Rotate doors closed and make sure moveable

center sealing portion of the door aligns with the

VWULNHU,IWKHGRRUZLOOQRWVHOIFORVHDIWHU

reinstalling, remove door, turn door upside down,

FKHFNDOLJQPHQWPDUNDQGDUURZWKHUHLVDQ
DOLJQPHQWPDUNRQWKHGRRUFORVXUHPHFKDQLVP,W

corresponds to an alignment arrow on the plastic
ring. Rotate door closure mechanism to align mark

DQGDUURZUHLQVWDOOGRRU'RRULQ'RRUPRGHOVGR

not have the same closure mechanism on the right
hand door. You may notice a difference in closure.

Securely tape the door shut with masking tape or
have a second person support the door. Reinstall
the top hinge and torque the screws to 65 in-lbs
(7.34 N-m).

C

Be sure to reinstall the ground wire and strain

relief to the top hinge.

'

Reinstall hinge cover.

NOTE:

Ensure wires are not

pinched or under screw bosses before tightening
screws.

3

REMOVE THE REFRIGERATOR
DOORS (cont)

Note: For proper installation later, please follow
the next step carefully.

)

Remove the tape and keeping the door as

straight as possible, open the door to 90º then lift
straight up to remove it.

REMOVE OPPOSITE DOOR

)ROORZWKHVDPHSURFHGXUHRQWKHRSSRVLWHGRRU

There are no water lines on the opposite side.

For Door in Door Models:

Securely tape the

inner and outer doors before installing or removing.
90º door alignment not required during installation
or removal for these models.

4

REMOVE CENTER HINGE (if necessary)

5HPRYHWKHƎVFUHZVVHFXULQJWKHFHQWHUKLQJH

to the cabinet.

8VH7GULYHUWRUHPRYHRXWERDUGVFUHZ

5

Remove
center screw

Lift up & off
center hinge

2SHQ'RRUWRƒ

Align flats with tab.

8QGHUVLGHRI
)UHVK)RRG'RRU

If door cannot be installed at 90° follow steps below:

,QVWDOOGRRUDWƒWRFDVHIURQW
,IVSDFHOLPLWVRSHQLQJGRRUWROHVVWKDQƒWKHQ
D5HPRYHGRRUFDUHIXOO\WXUQGRRUXSVLGHGRZQ
E&KHFNDOLJQPHQWRIGRRUFORVXUHPHFKDQLVPVKDIW

on underside of door. The flats on the shaft should

correspond to alignment tab on plastic ring or

mark on bottom end cap.

F,IVKDIWLVQRWDOLJQHGWRWDEPDUNXVLQJ´

Allen wrench, rotate door closure mechanism

shaft counterclockwise for right door and clock-

ZLVHIRUOHIWGRRU7KHQDOLJQIODWZLWKWDEPDUN
G,QVWDOOWKHGRRUDWƒ

Loosen outer
screws

Installation Instructions

INSTALLING THE REFRIGERATOR (Cont.)

INST

ALLA

TION INSTRUCTIONS

"Cargando la instrucción" significa que debes esperar hasta que el archivo se cargue y puedas leerlo en línea. Algunas instrucciones son muy grandes y el tiempo de carga depende de la velocidad de tu conexión a Internet.

Otros modelos de frigoríficos GE

Todos los frigoríficos GE