Wagan Tech WGN7505 - Manual de uso - Página 3

iOnBoost

™

V8 Torque by Wagan Tech

®

4

www.wagan.com

CHARGING THE IONBOOST

This product may arrive partially charged from the manufacturer� It is recommended to

fully charge the unit immediately after purchase and before using for the first time� Prior to

charging the unit, read and understand all instructions in this manual�

In order to prolong the life of the iOnBoost, be sure to fully recharge the unit after each use and

every 3 months even if the iOnBoost has not been used.

1. Insert the charging cable into the charging jack of the unit.
2. Plug the other end of the cable into any USB power source, such as an AC wall adapter or

the supplied DC charging adapter (engine must be opertating if charging iOnBoost in car).

3. Fully charge the unit (around 7 hours). Charging is complete when all battery status

indicator lights illuminate solid.

4. The battery status can be checked by tapping on the Power button once.

JUMPSTARTER

Read the instructions before using the iOnBoost!

JUMPSTART WARNINGS

Failure to follow these instructions may cause damage or explosion�

NOTE: Cranking an engine produces an accumulation of explosive gas above and near the

vehicle battery. Before any attempt to jumpstart a vehicle battery, make sure explosive gas is

dispelled from the area. Use a cardboard or newspaper fan to wave the gases away from the

battery for a few minutes. Do not use plastic or metal sheet—they can produce sparks and ignite

the gas.

• Jumpstart cables connected to iOnBoost are ALWAYS live! Never allow the clamps to touch

together or contact the same piece of metal.

• Do not attempt to jumpstart your vehicle when iOnBoost is below 80% charge (observe

battery status indicator lights on the unit—80%=4 solid lights).

• Only use this jumpstarter with 12 Volt negative–grounded systems. Most US vehicles have

negative (−) battery terminals connected to the vehicle frame. (Negative – Ground). Check

the negative battery terminal connecting wire to make sure it also connects to the frame.

• Make sure the jumpstarter clamps get connected to correct polarity (red to positive battery

terminal, black to vehicle frame for negative ground systems when jumpstarting).

• Use safety glasses to protect eyes while jumpstarting a battery.
• If the engine fails to start after two 3-second cranking attempts, discontinue jumpstart

procedure. Excessive engine cranking can damage the vehicle’s starter motor. Look for

other problems that may need to be corrected or call for professional service.

• Disconnecting cable clamps is always done in reverse order from connection sequence (see

Jumpstart Procedure below).

• Vehicles equipped with on-board computers may be affected if the engine battery is

jumpstarted. Read your vehicle owner’s manual before attempting to start the vehicle to

determine if external starting assistance can be used.