Wagan Tech WGN7505 - Manual de uso - Página 4

©2019 Wagan Corporation. All Rights Reserved.

Wagan Tech and

wagan.com

are trademarks of Wagan Corporation.

User’s Manual—Read before using this equipment

5

• If the iOnBoost is overloaded while in the jumpstart mode, quickly disconnect the negative

then positive clamps. All functions on the iOnBoost will not operate if the unit was

overloaded. To recover from overload, let the unit rest for 10 minutes then plug it into a

power source for a few minutes to reset the unit.

Jumpstart Procedure

1. Turn off the vehicle ignition and all accessories (radios, lights, air conditioners), and

disconnect electronic devices.

2. Set the emergency brake and put vehicles with automatic transmission in park position.
3. Determine the polarity of the vehicle’s battery terminals. The positive (POS, P, +) battery

terminal usually is red and the negative (NEG, N, −) terminal is usually black. If you are

unsure, first refer to the vehicle owner’s manual. Make sure the negative battery terminal is

also connected to the vehicle frame.

4. Insert the orange plug of the jumper cables into the iOnBoost’s jumper terminal. When fully

inserted, the red and green lights on the cable safety block should both flash alternately.

Use only the jumpstarting clamps provided in this package� Unauthorized parts may

cause serious damage or injur y�

5. Securely connect the positive (+) red clamp to the positive (POS, P, +) terminal of the vehicle

battery or the remote positive (+) terminal if equipped.

6. Securely connect the negative (−) black clamp to a non-moving, metal part of the engine or

frame as far away from the vehicle battery as possible.

7. When the clamps are properly connected to the battery, the green light on the cable safety

block will illuminate (a three-second delay is normal). When the light illuminates steady

green, it is safe to proceed in these instructions. If the light fails to illuminate steady green or

if any red lights illuminate, consult the troubleshooting section of this manual.

8. Place unit on a secure surface away from moving parts.
9. Start vehicle engine. Stop if the vehicle does not start after 3 to 4 seconds of engine

cranking. Wait 3 to 4 minutes, then try again. If engine does not start after second attempt,

discontinue cranking and consult a professional.

10. The internal safety timer will automatically disconnect the circuit after 90 seconds to

prevent the vehicle battery from reverse charging the unit. Both the red and green lights

will illuminate steady. If your vehicle still has not started, disconnect the cables and try the

procedure again.

11. When finished, disconnect the clamps in reverse sequence of connecting procedure—

first disconnect negative (black), then positive (red) clamps. Do not let the clamps touch

each other.

12. Disconnect the jumper cable assembly from the unit.
13. When convenient, completely charge the iOnBoost battery.
14. Store the unit and charge adapters in a cool, dry environment, away from flammable

materials. Remember to fully charge the unit every three months.