MANTENIMIENTO; CONSEJOS DE SOLUCIÓN DE PROBLEMAS; SAVE THESE INSTRUCTIONS; Read all instructions before using this Heater.; IMPORTANT SAFETY INFORMATION; CAUTION; WARNING - Lasko 2 x LKO-5790 - Manual de uso - Página 2

Lasko 2 x LKO-5790

Calentador Lasko 2 x LKO-5790 - Manual de uso, léela gratuitamente en línea en formato PDF. Esperamos que esto te ayude a resolver cualquier duda que puedas tener. Si tienes más preguntas, contáctanos a través del formulario de contacto.

Índice:

Cargando la instrucción

Rev. C 4/13

2

5790ES

11

5790ES

Rev. C 4/13

MODELO 5790

MANTENIMIENTO

Para reducir el riesgo de choque eléctrico e incendio por favor obedezca las siguientes instrucciones.

Limpiar el Calefactor regularmente ayudará a mantener su eficiencia.

- Siempre desconecte el cable eléctrico antes de mover, reparar o limpiar.

-

NUNCA

coloque el Calefactor dentro de o cerca de agua. NO SUMERJA EL CALEFACTOR EN AGUA

- Limpie el Calefactor solamente con una aspiradora equipada con un accesorio de cepillo; la aspiradora

quitará el polvo y los desperdicios del interior del Calefactor.
- Aspire las parrillas de entrada cada dos semanas; esto ayudará a mantener el rendimiento óptimo del calefactor.

- Use un cepillo de dientes u otro cepillo de cerdas suaves para aflojar suavemente cualquier polvo que

no haya sido retirado por la aspiradora
-

NUNCA

intente desarmar el Calefactor.

- Limpie el cuerpo del Calefactor únicamente con un trapo suave.
-

NUNCA

use ALCOHOL o SOLVENTES tales como gasolina, bencina, disolvente de pinturas u otros

limpiadores duros.

REPARACIONES

:

Toda otra reparación, con excepción del mantenimiento general del usuario, debe ser realizada por un

representante autorizado de reparaciones.

ALMACENAMIENTO:

Almacene el Calefactor con estas instrucciones en la caja original en un lugar fresco y seco

.

CONSEJOS DE SOLUCIÓN DE PROBLEMAS

Si su calefactor se apaga inesperadamente o no funciona,

el elemento de seguridad arriba mencionado podría haber

sido activado para evitar el sobrecalentamiento.
1. Asegúrese que el cable eléctrico esté conectado a un

tomacorriente eléctrico en funcionamiento.

2. Verifique la posición de su Temperatura. El Calefactor

puede haberse apagado por haber alcanzado la posición

de temperatura deseada.

3.

Si su Calefactor opera durante varios minutos y se apaga

repetidamente, es posible que el mismo requiera limpieza.

Ver la sección de Mantenimiento abajo.

Si usted tiene un problema que no pueda ser resuelto

siguiendo los pasos enumerados arriba, comuníquese con

Asistencia Técnica al 1-800-233-0268, de lunes a viernes,

entre las 8 am y las 5 m EST.

ELEMENTOS DE SEGURIDAD

1. Hay un protector de sobrecarga térmica incorporado para

evitar el sobrecalentamiento.

2. Si se alcanza una temperatura de sobrecalentamiento,

el Calefactor se apagará automáticamente. Sólo podrá

retomar el funcionamiento cuando el usuario reinicie la

unidad.

Para Reiniciar el Calefactor:

1. Desconecte el Calefactor y espere 10 minutos hasta que

la Unidad se enfríe.

2. Después que el Calefactor se haya enfriado, conecte

la unidad a un tomacorriente eléctrico de 120V~ y siga

las instrucciones de funcionamiento descriptas en este

manual.

SAVE THESE INSTRUCTIONS

ALWAYS PLUG HEATERS DIRECTLY INTO A WALL OUTLET/RECEPTACLE. NEVER USE WITH AN EXTENSION CORD. DO

NOT PLUG HEATER INTO ANY OTHER CORD CONNECTED DEVICE, SUCH AS A POWER STRIP, SURGE PROTECTOR,

MULTIPLE OUTLET ADAPTER, CORD REEL OR OUTLET-TYPE AIR FRESHENER. THE USE OF SUCH DEVICES MAY CREATE

A FIRE HAZARD. PLUG UNIT DIRECTLY INTO A 120V WALL OUTLET ONLY.

FAULTY WALL OUTLET CONNECTIONS MAY CAUSE THE WALL OUTLET TO OVERHEAT. BE SURE THAT HEATER PLUG

FITS TIGHTLY INTO OUTLET BEFORE EACH USE. DURING USE, CHECK TO MAKE CERTAIN THE HEATER PLUG IS

NOT OVERHEATING. IF NECESSARY HAVE A QUALIFIED ELECTRICIAN CHECK AND/OR REPLACE THE WALL OUTLET. DO

NOT USE THIS HEATER WITH ANY SOLID STATE SPEED CONTROL DEVICES.

• Make certain that the power source conforms to the electrical requirements of the Heater.

• E x t r e m e c a u t i o n i s n e c e s s a r y w h e n a n y H e a t e r i s u s e d b y o r n e a r c h i l d r e n o r i n v a l i d s

. Th e H e a t e r should not be le f t

o p e r a t i n g u n a t t e n d e d .

Never leave children unattended when the heater is on or plugged in.

• This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended

to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact

a qualified electrician. Do not attempt to defeat this safety feature.

• DO NOT use the Heater in areas where gasoline, paint, or flammable liquids are used or stored. DO NOT use Heater in locations

where flammable or explosive chemicals are stored, or in wet atmospheres.

• Do not operate any Heater with a damaged cord or plug or after the Heater malfunctions

, or has been dropped or damaged in any

manner. To disconnect Heater, turn the Heater OFF then remove the plug from the outlet.

• Always unplug Heater when not in use. Unplug power cord before servicing or moving the Heater.

• Do not insert or allow fingers or foreign objects to enter any ventilation or exhaust opening as it may cause an electric shock, fire, or

damage the Heater. Do not block or tamper with the Heater in any manner while it is in operation.

• Do not block air intakes or exhaust in any manner. Do not place on soft surfaces, like a bed, where openings

may become blocked. Do not depend on the on/off

switch as the sole means of disconnecting power when servicing or moving the

heater.

Always unplug the power cord.

Read all instructions before using this Heater.

IMPORTANT SAFETY INFORMATION

When using electrical appliances, these instructions and warnings should always be

followed to reduce the risk of fire, electrical shock and injury to persons:

WARNING

CAUTION

• Always place the Heater on a stable, flat, level surface when operating, to avoid the chance of the Heater overturning. Locate the Power Cord so

the Heater or other objects are not resting on it. DO NOT

run Power Cord under carpeting.

DO NOT

cover Power Cord with throw rugs, runners, or

similar coverings as this may cause cord to overheat. Arrange Power Cord away from room traffic and where it will not be tripped

over.

• This Heater is HOT when in use. To avoid burns, do not let bare skin touch hot surfaces. Always use handle when moving this Heater. Keep

combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9 m) from the front of the Heater and keep

them at least 1 foot (0.3 m) from the sides and rear.

• This Heater is not intended for use in wet or damp locations. This Heater is not intended for use in bathrooms, laundry areas and similar indoor

locations. NEVER

locate a Heater where it may fall into a bathtub or other water container.

• DO NOT

use Heater outdoors.

• Remote controls for other appliances or electronic equipment can sometimes interfere with the operation of this Heater. If this occurs, move the

Heater to another location or discontinue use of other equipment.

• Keep Heater remote control unit away from chairs and your bed where it may be sat or laid upon and inadvertently turn on the Heater.

• This Heater is not suitable for use in agricultural facilities including areas where livestock, poultry or other animals are confined. Please

refer

to National Electric Code (NEC) Article 547-7 (2008), or applicable state or local codes or standards relating to electrical requirements for

Agricultural Buildings.

THIS HEATER DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE 547-7 (2008).

• This Heater is not suitable for use in hazardous locations. Please refer to National Electric Code (NEC) Article 500 or applicable state or

local codes

or standards relating to electrical requirements for Hazardous locations.

THIS HEATER DOES NOT MEET THE REQUIREMENTS OF NEC

ARTICLE 500 (2008).

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the

equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the

dealer or an experienced radio/TV technician for help. The user is cautioned that changes and modifications made to the equipment without the

approval of manufacturer could void the user’s authority to operate this equipment.

Please contact Customer Service at 800-233-0268 Monday through Friday from 8am to 5pm EST for assistance.

WARNING

"Cargando la instrucción" significa que debes esperar hasta que el archivo se cargue y puedas leerlo en línea. Algunas instrucciones son muy grandes y el tiempo de carga depende de la velocidad de tu conexión a Internet.

Resumen

Página 2 - MANTENIMIENTO; CONSEJOS DE SOLUCIÓN DE PROBLEMAS; SAVE THESE INSTRUCTIONS; Read all instructions before using this Heater.; IMPORTANT SAFETY INFORMATION; CAUTION; WARNING

Rev. C 4/13 2 5790ES 11 5790ES Rev. C 4/13 MODELO 5790 MANTENIMIENTO Para reducir el riesgo de choque eléctrico e incendio por favor obedezca las siguientes instrucciones. Limpiar el Calefactor regularmente ayudará a mantener su eficiencia. - Siempre desconecte el cable eléctrico antes de mov...

Página 3 - OPERATION; CONTROL REMOTO

OPERATION (Figure 1) 1. Carefully remove the Heater from the plastic bag and the carton.2. Place the Heater on a firm and level surface.Plastic or rubber tabs, like the feet on this unit, may stick to furniture surfaces and/or hardwood floors. The unit may leave a residue that could darken, stain or...

Página 4 - FUNCIONAMIENTO; REMOTE CONTROL

Rev. C 4/13 4 5790ES Rev. C 4/13 9 5790ES MODEL 5790 FUNCIONAMIENTO (Figura 1) 1. Cuidadosamente retire el Calefactor de la bolsa y de la caja.2. Coloque el Calefactor sobre una superficie firme y plana. Los tacos de plástico o hule, tales como las patas de esta unidad, pueden pegarse a la superfic...

Otros modelos de calentadores Lasko

Todos los calentadores Lasko