Página 23 | Monogram ZIR361NPRII - Manual de uso

Página 2 - ANTES DE COMENZAR; IMPORTANTE; PRECAUCIÓN; ADVERTENCIA; FORMA ADECUADA DE DESCARTAR SU ELECTRODOMÉSTICO

4 31-1000600 Rev. 0 Safety Information ANTES DE COMENZAR Lea estas instrucciones en su totalidad y atentamente. • IMPORTANTE – Conserve estas instrucciones para uso del inspector local. Cumpla con todos los códigos y ordenanzas gubernamentales. • Nota para el Instalador – Asegúrese de que el Com...

Página 4 - Installation Instructions - Reversing the Door Swing; WARNING; Risque de

9 31-1000600 Rev. 0 Installation Instructions - Reversing the Door Swing STEP 1 REMOVE UPPER ENCLOSURE Ŷ Open the front cover of the enclosure to 90°. Locate filter and filter removal tool. Filter should be as shown. Ŷ 5RWDWH¿OWHUóWXUQ counterclockwise (use ¿OWHUUHPRYDOWRROLI needed). Ŷ 3XOO¿OWHUWR...

Página 5 - STEP 2 REMOVE DOOR; Door Hinge Pinch

10 31-1000600 Rev. 0 Installation Instructions - Reversing the Door Swing STEP 2 REMOVE DOOR Ŷ Open the door to the open position. Ŷ Have a second person support the open door. Ŷ Remove 2 T30 Torx screws securing the bottom hinge to the case. Ŷ Remove the 2 T30 Torx screws securing the top hinge...

Página 8 - STEP 4 INSTALL ANTI-TIP BRACKET; Dual install

21 31-1000600 Rev. 0 Installation Instructions - Dual Integrated Installation STEP 4 INSTALL ANTI-TIP BRACKET (Cont.) Ŷ Measure and mark from the RH side of the opening per the table above depending on the size of the RH unit you are installing. Ŷ Measure and mark again from the RH side of the ope...

Página 9 - Electrical Shock Hazard.; Trisque de

24 31-1000600 Rev. 0 Installation Instructions - Dual Integrated Installation STEP 7 INSERTING/SECURING INTO CABINET SURROUND Ŷ Plug both units into the outlet in the wall. Ŷ Find the installation string that is attached to the door of the unit; this is to be used as you are pushing the unit back ...

Página 10 - ON; STEP 12 START ICEMAKER; OFF; CAUTION; ATTENTION

28 31-1000600 Rev. 0 STEP 12 START ICEMAKER (freezer models) When the freezer has been connected to the water supply, set the power switch to ON . Throw away the first full bucket of ice to allow the water line to clear. Be sure nothing interferes with the sweep of the feeler arm. When the bin fil...

Página 13 - STEP 7 INSERTING/SECURING INTO

41 31-1000600 Rev. 0 Installation Instructions - Dual Retro-Fit Installation STEP 7 INSERTING/SECURING INTO CABINET SURROUND Ŷ Slowly walk both units into opening making sure not to touch the cabinetry on the sides and top to prevent damage. The back side of the top and side retro trims should be ...

Página 17 - STEP 11 START ICEMAKER (freezer models)

56 31-1000600 Rev. 0 Installation Instructions - Single Integrated Installation STEP 11 START ICEMAKER (freezer models) A newly-installed freezer may take 12–24 hours to begin making ice. The icemaker will produce seven cubes per cycle—approximately 15 cycles in a 24-hour period, depending on freez...

Página 19 - Installation Instructions - Stainless Door Panel; Door Trim Pinch; STEP 1 INSTALL STAINLESS PANEL; Risque de pincement

59 31-1000600 Rev. 0 Installation Instructions - Stainless Door Panel Stainless Steel Door Panel Kits are available with either Euro handles or Pro handles. Stainless steel panel is fully assembled with brackets and handle already installed as a LH or RH swing door. LH door kits can be modified to f...

Página 21 - /4” CUSTOM DECORATIVE PANEL DIMENSIONS; Design Guide - Custom Overlay Door Panel; CUSTOM HANDLE DESIGN GUIDE; Door Trim Pinch Point

64 31-1000600 Rev. 0 3/4” CUSTOM DECORATIVE PANEL DIMENSIONS For a more custom appearance, overlay panels may be installed to give a flush appearance with surrounding cabinets. The overlay panel must be 3/4” (1.91cm) thick. Panel attaches to included brackets to provide mounting to the appliance doo...

Monogram ZIR361NPRII - Manual de uso - Página 23

Índice:

Resumen