BEFORE YOU START; AVANT DE COMMENCER | ANTES DE COMENZAR; ☑ Turn off Power at Breaker - Big Ass Fans MK-I61-051800A729 - Manual de uso - Página 2

Ventilador de techo Big Ass Fans MK-I61-051800A729 - Manual de uso, léela gratuitamente en línea en formato PDF. Esperamos que esto te ayude a resolver cualquier duda que puedas tener. Si tienes más preguntas, contáctanos a través del formulario de contacto.
Índice:
- Página 2 – BEFORE YOU START; AVANT DE COMMENCER | ANTES DE COMENZAR; ☑ Turn off Power at Breaker
- Página 4 – Install Mounting Bracket; Outlet Box; Boîte de dérivation | Caja de distribución; Concrete Ceiling; Plafond en béton | Techo de concreto; Wood Ceiling Joist; Solive de plafond en bois | Viga de techo de madera
- Página 5 – Ground Wire
- Página 7 – Install Motor Cover; Mise en place du cache moteur | Instalar la cubierta del motor; Motor Cover
- Página 8 – Prepare Wiring Cover and Trim; Insert wiring; Sloped Ceiling; Plafond incliné | Techo inclinado; Flat Ceiling; Plafond non incliné | Techo plano
- Página 9 – Raise fan to mounting bracket. Align rib in; Power wires; Suspension du ventilateur | Colgar el ventilador
- Página 11 – Secure Safety Cable; Anchor Hook; Crochet d’ancrage | Gancho de anclaje
- Página 12 – Secure Wiring Cover; Building Structure; Shackle
- Página 13 – Montage des pales | Instalar las aspas aerodinámicas; of fan from previous airfoil to prevent fan from tilting.; Make sure numbered sticker on; When finished, repeat tightening sequence.; Verify all six screws are fully tightened by
- Página 15 – Top View; Vue du dessus | Vista superior; Side View; Vue latérale | Vista lateral
- Página 17 – Install Wiring Harness and Mounting Plate; Disconnect power before wiring fan.
- Página 18 – Wiring
- Página 20 – Ensure terminal is; Secure Safety Cable
- Página 22 – Secure Safety Clips and Wiring Cover; Safety Clip; Structure du bâtiment | Estructura del edificio
- Página 26 – –10 V Wiring (for fans ordered with 0–10 V option); controller supplying a 0–10 V signal.; Make sure each controller has a maximum current
- Página 27 – Câbler le ventilateur | Cablear el ventilador; Route 0–10 V wiring into downrod and connect to 0–10 V wires; before securing downrod to fan; Route 0–10 V wiring through mounting plate and connect to 0–10 V; Fan 0–10 V Input Channel
- Página 28 – Removing Covers and Light Kit; Universal Mount
REV. D | 12/05/2019 | © 2019 DELTA T LLC Ι ALL RIGHTS RESERVED.
WARNING: Installation must be in accordance with the requirements set forth by the
National Electrical Code (NEC, United States), ANSI/NFPA 70, and all national and local
codes.
The ground wire must be connected to the supply ground and its length must be longer
than the safety cable.
A means for disconnection must be incorporated in the fixed wiring in accordance with the
wiring rules.
The mounting/fixing means for attachment to the ceiling such as hooks or other devices
shall be fixed with a sufficient strength to withstand four times the weight of the ceiling fan.
AVERTISSEMENT : Les ventilateurs doivent être installés conformément au National Electrical Code
(NEC, code américain de l’électricité), à la norme ANSI/NFPA 70 et à toute autre règlementation locale et
national en vigueur.
Le fil de terre doit être relié à la terre de l’alimentation et il doit être plus long que l’élingue de sécurité.
Un dispositif de sectionnement doit être intégré aux installations électriques fixes, conformément aux
normes de câblage.
Le moyen de fixation/ancrage utilisé pour accrocher le ventilateur au plafond (crochets ou autre) doit
être suffisamment solide pour supporter quatre fois le poids du ventilateur.
ADVERTENCIA: La instalación debe cumplir con el Código Eléctrico Nacional (NEC, Estados Unidos),
ANSI/NFPA 70 y los códigos locales y nacionales.
El cable de tierra debe estar conectado a la tierra de la alimentación y debe ser más largo que el cable
de seguridad.
En el cableado fijo se debe incorporar medios de desconexión de acuerdo con las reglas del cableado.
Los medios de montaje/fijación utilizados para sujetar la unidad al techo, tales como ganchos u otros
dispositivos, se deben asegurar con fuerza suficiente para soportar cuatro veces el peso del ventilador.
BEFORE YOU START
AVANT DE COMMENCER | ANTES DE COMENZAR
☑ Turn off Power at Breaker
Coupez le courant au niveau du disjoncteur | Corte la energía desde el interruptor
Input Voltage:
100–277 VAC, 1 Φ, 50~60 Hz
Tension d’entrée :
100–277 V CA, 50~60 Hz |
Tensión de entrada:
100–277 VCA, 50~60 Hz.
Do not connect the fan to a damaged power source. Do
not attempt to resolve electrical failures on your own.
Contact a licensed electrician if you are uncomfortable
performing electrical work. A licensed electrician must
install the fan if required by local code.
Ne branchez jamais le ventilateur à une source de courant endommagée.
N’essayez pas de réparer une panne électrique seul. Contactez un
électricien professionnel si vous ne vous sentez pas à l’aise avec
les travaux électriques. La règlementation locale peut exiger que le
ventilateur soit installé par un professionnel.
Nunca conecte el ventilador a una fuente de alimentación dañada. No
intente reparar desperfectos eléctricos por su cuenta. Si no se siente
cómodo realizando trabajos eléctricos, llame a un electricista registrado.
Si el código local así lo exige, el ventilador debe ser instalado por un
electricista registrado
.
Models and Maximum Weight | Modèles et poids maximum | Modelos y peso máximo:
MK-i61-051806 (38.3 lb [17.4 kg]), MK-i61-061806 (40.1 lb [18.2 kg]), MK-i61-071806 (41.6 lb [18.9 kg]), MK-i61-051800 (33.1 lb [15.0 kg]),
MK-i61-061800 (34.9 lb [15.8 kg]), MK-i61-051906 (39.3 lb [17.8 kg]), MK-i61-061906 (41.1 lb [18.6 kg]), MK-i61-071906 (42.6 lb [19.3 kg]),
MK-i61-051900 (33.1 lb [15.0 kg]), MK-i61-061900 (34.9 lb [15.8 kg])
"Cargando la instrucción" significa que debes esperar hasta que el archivo se cargue y puedas leerlo en línea. Algunas instrucciones son muy grandes y el tiempo de carga depende de la velocidad de tu conexión a Internet.
Resumen
REV. D | 12/05/2019 | © 2019 DELTA T LLC Ι ALL RIGHTS RESERVED. WARNING: Installation must be in accordance with the requirements set forth by the National Electrical Code (NEC, United States), ANSI/NFPA 70, and all national and local codes.The ground wire must be connected to the supply grou...
TOUS DROITS RÉSERVÉS. | TODOS LOS DERECHOS RESERVADOS. 3 1. Install Mounting Bracket Mise en place du support de fixation | Instalar el soporte de montaje Outlet Box Boîte de dérivation | Caja de distribución WARNING: Mount only to an outlet box marked acceptable for fan support (70 lb [31.8 kg])....
REV. D | 12/05/2019 | © 2019 DELTA T LLC Ι ALL RIGHTS RESERVED. 4 2. Connect Safety Cable, Ground Wire, and Wiring Harness Raccordement de l’élingue de sécurité, du fil de terre et du faisceau de filsConectar el cable de seguridad, el cable de tierra y el arnés del cableado 1. Connect safety ...
Otros modelos de ventiladores de techo Big Ass Fans
-
Big Ass Fans FR127C-U1H00-3L00-09258-258P61
-
Big Ass Fans FR127C-U1H00-3L00-09259-259P61
-
Big Ass Fans FR127C-U1H00-3L0209258-532P610
-
Big Ass Fans MK-HK4-04240001A258F221G10
-
Big Ass Fans MK-HK4-04240001A258F222G10
-
Big Ass Fans MK-HK4-04240001A259F221G10
-
Big Ass Fans MK-HK4-04240001A470F221G10
-
Big Ass Fans MK-HK4-04240001A470F222G10
-
Big Ass Fans MK-HK4-04240001A471F221G10
-
Big Ass Fans MK-HK4-04240001A471F222G10