Removing Covers and Light Kit; Universal Mount - Big Ass Fans MK-I61-051800A729 - Manual de uso - Página 28

Ventilador de techo Big Ass Fans MK-I61-051800A729 - Manual de uso, léela gratuitamente en línea en formato PDF. Esperamos que esto te ayude a resolver cualquier duda que puedas tener. Si tienes más preguntas, contáctanos a través del formulario de contacto.
Índice:
- Página 2 – BEFORE YOU START; AVANT DE COMMENCER | ANTES DE COMENZAR; ☑ Turn off Power at Breaker
- Página 4 – Install Mounting Bracket; Outlet Box; Boîte de dérivation | Caja de distribución; Concrete Ceiling; Plafond en béton | Techo de concreto; Wood Ceiling Joist; Solive de plafond en bois | Viga de techo de madera
- Página 5 – Ground Wire
- Página 7 – Install Motor Cover; Mise en place du cache moteur | Instalar la cubierta del motor; Motor Cover
- Página 8 – Prepare Wiring Cover and Trim; Insert wiring; Sloped Ceiling; Plafond incliné | Techo inclinado; Flat Ceiling; Plafond non incliné | Techo plano
- Página 9 – Raise fan to mounting bracket. Align rib in; Power wires; Suspension du ventilateur | Colgar el ventilador
- Página 11 – Secure Safety Cable; Anchor Hook; Crochet d’ancrage | Gancho de anclaje
- Página 12 – Secure Wiring Cover; Building Structure; Shackle
- Página 13 – Montage des pales | Instalar las aspas aerodinámicas; of fan from previous airfoil to prevent fan from tilting.; Make sure numbered sticker on; When finished, repeat tightening sequence.; Verify all six screws are fully tightened by
- Página 15 – Top View; Vue du dessus | Vista superior; Side View; Vue latérale | Vista lateral
- Página 17 – Install Wiring Harness and Mounting Plate; Disconnect power before wiring fan.
- Página 18 – Wiring
- Página 20 – Ensure terminal is; Secure Safety Cable
- Página 22 – Secure Safety Clips and Wiring Cover; Safety Clip; Structure du bâtiment | Estructura del edificio
- Página 26 – –10 V Wiring (for fans ordered with 0–10 V option); controller supplying a 0–10 V signal.; Make sure each controller has a maximum current
- Página 27 – Câbler le ventilateur | Cablear el ventilador; Route 0–10 V wiring into downrod and connect to 0–10 V wires; before securing downrod to fan; Route 0–10 V wiring through mounting plate and connect to 0–10 V; Fan 0–10 V Input Channel
- Página 28 – Removing Covers and Light Kit; Universal Mount
REV. D | 12/05/2019 | © 2019 DELTA T LLC Ι ALL RIGHTS RESERVED.
28
Removing Covers and Light Kit
Dépose du couvre-fil, du cache moteur et du kit d’éclairage
Retirar las cubiertas y el kit de iluminación
Use a long, thin object such as a small allen wrench or pen tip to press tab on wiring
cover, light kit, or lower cover. While pressing tab, turn cover or light kit counterclockwise
and slide down to remove.
À l’aide d’un objet long et fin, comme une petite clé Allen ou la pointe d’un stylo, appuyez sur la languette située
au niveau du couvre-fils, du cache moteur ou du kit d’éclairage. Tout en maintenant la languette enfoncée, faites
pivoter le couvre-fils, le cache moteur ou le kit d’éclairage dans le sens inverse des aiguilles d’une montre et
faites-le coulisser vers le bas.
Use un objeto largo y delgado (por ejemplo, una pequeña llave Allen o la punta de un bolígrafo) para presionar
la pestaña de la tapa del cableado, el kit de iluminación o la cubierta inferior. Con la pestaña presionada, gire la
tapa o el kit de iluminación en el sentido contrario a las agujas del reloj y deslice hacia abajo para retirarlo.
Universal Mount
Fixation universelle
Montura universal
Flush Mount
Montage affleurant
Instalación a ras
Light Kit or Lower Cover
Kit d’éclairage ou cache inférieur
Kit de la luz o cubierta inferior
"Cargando la instrucción" significa que debes esperar hasta que el archivo se cargue y puedas leerlo en línea. Algunas instrucciones son muy grandes y el tiempo de carga depende de la velocidad de tu conexión a Internet.
Resumen
REV. D | 12/05/2019 | © 2019 DELTA T LLC Ι ALL RIGHTS RESERVED. WARNING: Installation must be in accordance with the requirements set forth by the National Electrical Code (NEC, United States), ANSI/NFPA 70, and all national and local codes.The ground wire must be connected to the supply grou...
TOUS DROITS RÉSERVÉS. | TODOS LOS DERECHOS RESERVADOS. 3 1. Install Mounting Bracket Mise en place du support de fixation | Instalar el soporte de montaje Outlet Box Boîte de dérivation | Caja de distribución WARNING: Mount only to an outlet box marked acceptable for fan support (70 lb [31.8 kg])....
REV. D | 12/05/2019 | © 2019 DELTA T LLC Ι ALL RIGHTS RESERVED. 4 2. Connect Safety Cable, Ground Wire, and Wiring Harness Raccordement de l’élingue de sécurité, du fil de terre et du faisceau de filsConectar el cable de seguridad, el cable de tierra y el arnés del cableado 1. Connect safety ...
Otros modelos de ventiladores de techo Big Ass Fans
-
Big Ass Fans FR127C-U1H00-3L00-09258-258P61
-
Big Ass Fans FR127C-U1H00-3L00-09259-259P61
-
Big Ass Fans FR127C-U1H00-3L0209258-532P610
-
Big Ass Fans MK-HK4-04240001A258F221G10
-
Big Ass Fans MK-HK4-04240001A258F222G10
-
Big Ass Fans MK-HK4-04240001A259F221G10
-
Big Ass Fans MK-HK4-04240001A470F221G10
-
Big Ass Fans MK-HK4-04240001A470F222G10
-
Big Ass Fans MK-HK4-04240001A471F221G10
-
Big Ass Fans MK-HK4-04240001A471F222G10